Multi-functional lifter
Industrial vacuum load handlers allow lifting, turning and turning loads as diverse as bags, boxes, containers, drums, pallets, toilets, marble, porcelain and solid surfaces up to 265Kgs. Operation is intuitive, smooth and fast performing all the functions of grabbing the load, raising it, lowering and releasing the load from a single control, the manipulator handle.
Lifting is simple and safe, both for people and for the product. They can be installed to optimize any manufacturing and handling process, in logistics warehouses, for picking and order preparation. Its ergonomics, functionality and safety reduce effort and optimize productivity, reducing user fatigue and injuries.
How does the vacuum manipulator work?
The manipulator uses vacuum to hold and lift the load. The air is guided through a filter and an air pipe, to raise the lifting tube with which the manipulator is equipped. The vacuum within the lift tube is regulated from the manipulator’s control handle. This manipulator is where the suction unit is attached, which is the one that will be in contact with the material to be handled.
When the partial vacuum increases, the lift tube shrinks and lifts the load. When the partial vacuum is reduced, the lift tube is stretched, lowering the load. The sniffer keeps the load safely gripped until it reaches the ground. In the event of power loss or a power outage, a safety valve acts in such a way that the load descends in a smooth and controlled way to the ground.
We have stainless steel handling equipment for the food, pharmaceutical, cosmetic, chemical, and logistics industries. We also carry out special applications for clean areas, corrosive environments and ATEX areas.
What sipper to use?
We develop standard and special suction pumps on request, made to measure according to the type of load, weight, suction surface and the type of handling required for each product and application.
We can handle boxes with the product inside, both open and closed, with seal or staples.
Irregular boxes with fragile products inside the boxes can also be handled and lifted and stacked.
We develop standard and special suction pumps on request, made to measure according to the type of load, weight, suction surface and the type of handling required for each product and application.
We can handle boxes with the product inside, both open and closed, with seal or staples.
Handling of open boxes with 30kg of weight inside
Manipulator with 2 fixed suction cups 1 adjustable
Handling of irregular boxes with sanitary porcelain within 40Kgs
Elevation of irregular boxes with sanitary porcelain within 40kgs
Suction cup design with 4 suction cups for handling bathtubs
Suction cup design with 2 top and 1 side suction cups
Suction design with 3 side suction cups for handling Eurobox plastic drawers
Suction device for cardboard boxes with 80kgs
Suction bag for sacks
Suction device for boards and plates
How is the vacuum generated?
The vacuum pump is what runs the entire system. The vacuum is generated by means of a high-performance, low-consumption vacuum motor-pump. This motor pump can be installed up to 30m away from the lifting point. A remote control can be installed to operate the pump without leaving the duty point.
Where to install the load handler?
They can be installed on our light profile jib cranes and overhead cranes. The overhead crane or jib crane supports the lifting equipment. We offer a wide range of lifting systems such as column cranes, jib cranes, light overhead cranes, suspension cranes, mono-rail cranes, low height cranes, Bridge cranes with frame structure. We provide from the design to the execution of the “turnkey” tailor-made project for the handling of almost any type of material.
Vacuum manipulator on a column crane with a 6m arm
Vacuum manipulator on portable crane
Aluminum light profile overhead crane
